[Aug 16, 2026] Get New H12-811_V1.0 Practice Test Questions Answers [Q89-Q109]

Share

[Aug 16, 2026] Get New H12-811_V1.0 Practice Test Questions Answers

H12-811_V1.0 Dumps and Exam Test Engine


Huawei H12-811_V1.0 (HCIA-Datacom V1.0) Exam is a certification that is designed for professionals who want to demonstrate their expertise in data communication. H12-811_V1.0 exam covers a wide range of topics related to network architecture, protocols, security, and management. Candidates who pass H12-811_V1.0 exam earn the Huawei Certified ICT Associate in Datacom certification, which is recognized globally and is highly valued by employers.

 

NEW QUESTION # 89
As shown in the figure, the MAC address table of SWA is as follows. The switch cannot learn the MAC address of HOST A. Which of the following reasons is impossible?

  • A. HOST A does not send any data frame.
  • B. G0/0/1 of the switch is configured as an access interface.
  • C. MAC address learning is disabled in the VLAN to which HOST A belongs.
  • D. MAC address learning is disabled on G0/0/1 of the switch.

Answer: B


NEW QUESTION # 90
In the following figure, after the OSPF routers converge, in which state is the OSPF neighbor relationship between Router B and Router C?

  • A. Attempt
  • B. Full
  • C. 2-way
  • D. Down

Answer: C


NEW QUESTION # 91
When deploying ACL on Huawei equipment, which of the following descriptions is correct is ()

  • A. ACL can match the TCP/UDP port number of the packet, and can specify the range of port numbers
  • B. When calling ACL under the interface, it can only be applied to the outbound direction
  • C. The same ACL can be called under multiple interfaces
  • D. When ACL defines rules, it can only proceed in the order of 10, 20, 30
  • E. ACL cannot be used to filter OSPF traffic, because COSPF traffic does not use UDP protocol encapsulation

Answer: C


NEW QUESTION # 92
If the MAC address of an interface is 0OEO-FCEF-OFEC, what is its corresponding EUI-64 address? ()

  • A. 00EO-FCFF-FEEF-OFEC
  • B. 02EO-FCFF-FEEF-OFEC
  • C. 02EO-FCEF-FFFE-OFEC

Answer: A


NEW QUESTION # 93
On the network shown in the figure, Host A and Host B cannot communicate with each other.

  • A. TRUE
  • B. FALSE

Answer: A

Explanation:
Comprehensive Explanation: Host A and Host B cannot communicate because they are in different subnets.
Host A's IP address is 10.0.12.1/30, while Host B's IP address is 10.0.12.5/24. Since they are in different subnet ranges and there is no router in the diagram to perform inter-subnet routing, direct communication between them is not possible without a router to route traffic between the different subnets.


NEW QUESTION # 94
SWA and SWB run RSTP. Which of the following statements are true?

  • A. G0/0/2 of SWA is a designated port.
  • B. G0/0/3 of SWB is a backup port.
  • C. G0/0/3 of SWA is a designated port.
  • D. G0/0/3 of SWB is an alternate port.

Answer: A,C,D

Explanation:
Comprehensive Explanation: In RSTP (Rapid Spanning Tree Protocol), G0/0/3 of SWB is an Alternate Port because it provides a redundant path to the root bridge, while G0/0/3 of SWA is a Designated Port, forwarding traffic away from the root bridge. Similarly, G0/0/2 of SWA is also a Designated Port because it forwards traffic to other segments of the network. Alternate Ports are used to provide backup paths, while Designated Ports are the forwarding ports on a given segment.


NEW QUESTION # 95
Which of the following are related to the purpose of encapsulation and decapsulation? ()

  • A. Interworking between different networks
  • B. Encapsulation and decapsulation are important steps to realize the functions of different protocols
  • C. Shorten the length of the message
  • D. Encapsulation and decapsulation can complete network fault location

Answer: A


NEW QUESTION # 96
The IP address 192.168.1.127/25 represents a ( ) address.

  • A. Host
  • B. Broadcast
  • C. Network
  • D. Multicast

Answer: A

Explanation:
Detailed Explanation: With a subnet mask of /25, the IP range for this subnet would be 192.168.1.0 to
192.168.1.127. Here, 192.168.1.127 is the last usable address in the subnet, making it a valid host address rather than a network or broadcast address. This address falls within the range of available host addresses for that subnet.


NEW QUESTION # 97
The two switches shown in the figure below have both enabled the STP protocol, which port will eventually be in the Blocking state? ()

  • A. G0/0/2 port of STA
  • B. G0/0/3 port of STA
  • C. STB's G0/0/3 port

Answer: A


NEW QUESTION # 98
To ensure that the same data flow is forwarded on the same physical link, which load sharing method does the Eth-Trunk adopt? ()

  • A. Load sharing based on application layer information
  • B. Load sharing based on data packet inbound interface
  • C. Packet-based load sharing
  • D. Flow-based load sharing

Answer: D


NEW QUESTION # 99
Assuming that an administrator is running the command shown in the figure on an AR2200 router, which of the following statements about the configuration is true?
< Huawei > reset saved-configuration
Warning: The action will delete the saved configuration in the device.
The configuration will be erased to reconfigure. Continue? [Y/N]:

  • A. To clear the configuration file for next startup, select N.
  • B. The configuration file for next startup is retained.
  • C. To clear the configuration file for next startup, select Y.
  • D. The saved configuration file will be replaced by the running configuration file.

Answer: C

Explanation:
On Huawei routers running VRP, the reset saved-configuration command is used to delete the saved startup configuration file.
* Option A (Incorrect): This command does not replace the saved configuration with the running configuration. Instead, it deletes the saved startup configuration.
* Option B (Incorrect): The configuration file for the next startup is NOT retained. Instead, it is erased, meaning the device will boot with default settings if restarted.
* Option C (Correct): Selecting Y (Yes) confirms the deletion of the saved startup configuration file, meaning the router will no longer have a saved configuration at the next reboot.
* Option D (Incorrect): Selecting N (No) cancels the operation and keeps the saved startup configuration intact.
Thus, the correct answer is C. To clear the configuration file for next startup, select Y.
Reference:Huawei HCIA-Datacom Official Documentation - VRP Configuration Management


NEW QUESTION # 100
As shown in the figure, the administrator hopes that all hosts cannot access the Internet from 8:00 to 17:00 every day. Which ACL rule needs to be bound to traffic-filter outbound in the interface configuration of G0/0/1? () (Single-choice question)

  • A. time-range am9 to pm5 08:00 to 17:00 off-day # Acl number 2004 Rule 5 permit time-range am9 to pm5
  • B. time-range am9 to pm5 08:00 to 17:00 working-day # Ac1 number 2003 Rule 5 deny time-range am9 to pm560 H12-811HCIA-Datacom655 new question bank#
  • C. time-range am9 to pm5 07:00 to 18:00 daily # Acl number 2002 Rule 5 permit time-range am9 to pm5 #
  • D. time-range am9 to pm5 08:00 to 17:00 daily # Acl number 2001 Rule 5 deny time-range am9 to pm5 #

Answer: D


NEW QUESTION # 101
The router uses the sub-interface as the gateway of the host, and the P address of the gateway is 10.0.12.2. Which of the following commands can achieve this requirement? ()

  • A. Interface GigabitEthernet0/0/0.20 Dotlq termination viD.20 ip address10.0.12.2\n255.255.255.0 Arp broadcast enable#
  • B. Interface GigabitEthernet0/0/0.10 Dotlq termination viD.10 ip address10.0.12.2n255.255.255.0 Arp broadcast enable#
  • C. Interface GigabitEthernet0/0/0.20 Dotlq termination viD.10 ip address10.0.12.2n255.255.255.0 Arp broadcast enable#
  • D. Interface GigabitEthernet0/0/0.10 Dotlq termination viD.20 ip address10.0.12.2n255.255.255.0 Arp broadcast enable#

Answer: A,D


NEW QUESTION # 102
There is a WeB server in the private network that needs to provide HITP services to public network users. Therefore, the network administrator needs to configure NAT on the gateway router RTA.

  • A. (RTA-Serial1/0/1) nat server protocol top global 202.10.10.1 www inside192.168.1.18080
  • B. (RTA-Serial1/0/1) nat server protocol tcpglobal 192.168.1.1 www inside202.10.1 0.18080
  • C. RTA-Gigabitethernet0/0/1 nat server protocol tcp global 192.168.1.1 www inside 202.10.10.18080
  • D. (RTA-Gigabitethernet0/0/1) nat server protocol tcp global 202.10.10.1 www inside 192.168.1.18080

Answer: A


NEW QUESTION # 103
A network administrator uses the ping command to check for points of failure in the network. Which protocols will be used during this process?

  • A. UDR
  • B. ARP
  • C. TCP
  • D. ICMP

Answer: D

Explanation:
Comprehensive and Detailed In-Depth Explanation:
The ping command is used to test network connectivity by sending ICMP Echo Request messages to a destination host and waiting for ICMP Echo Reply responses.
* Correct Answer:
* (B) ICMP (Internet Control Message Protocol) is the protocol responsible for handling these echo requests and replies.
* Incorrect Options:
* (A) TCP (Transmission Control Protocol) is a connection-oriented protocol used for data transmission, not for network diagnostics like ping.
* (C) ARP (Address Resolution Protocol) is used to resolve MAC addresses from IP addresses, but it is not involved in the ping process.
* (D) UDR is not a valid protocol in this context.
Reference: Huawei HCIA-Datacom Network Troubleshooting Guide - ICMP and Ping Commands


NEW QUESTION # 104
Which of the following is correct regarding the configuration of the trunk port and access port on a switch?

  • A. Trunk ports can only send tagged frames.
  • B. Access ports can only send untagged frames.
  • C. Trunk ports can only send untagged frames.
  • D. Access ports can only send tagged frames.

Answer: B

Explanation:
Detailed Explanation:Access ports are configured for a single VLAN and thus send untagged frames by default. Trunk ports, conversely, handle traffic for multiple VLANs, tagging each frame with a VLAN ID.
(Reference: HCIA-Datacom Training Material, Switch Port Types and VLAN Tagging)


NEW QUESTION # 105
The network administrator of a certain company wants to uniformly divide the users who often access the company network from different switches to VLAN 10 when they frequently change office locations. Which of the following methods should be used to divide VLANs? ()

  • A. VLAN based on subnet
  • B. VLAN based on MAC. address
  • C. VLAN based on port
  • D. VLAN based on protocol

Answer: A


NEW QUESTION # 106
In order to distinguish between different users and provide different network services on the AP. Which of the following can be configured through configuration? ()

  • A. VT
  • B. VAC
  • C. D. WAP
  • D. B. VAP

Answer: A


NEW QUESTION # 107
As shown in the figure below. Which port of the following switches will be blocked? () (Single-choice question)

  • A. SWA's G0/0/3
  • B. SWC's G0/0/1
  • C. G0/0/3 of SWB

Answer: C


NEW QUESTION # 108
A company applies for a Class C IP address segment, but it must be allocated to 6 subsidiaries. The largest subsidiary has 26 computers. Different subsidiaries must be in different network segments. The netmask should be set to ().

  • A. 255.255.255.192
  • B. 255.255.255.0
  • C. 255.255.255.128
  • D. 255.255.255.224

Answer: D


NEW QUESTION # 109
......

2026 New Pass4Leader H12-811_V1.0 PDF Recently Updated Questions: https://testoutce.pass4leader.com/Huawei/H12-811_V1.0-exam.html